Nucleus-M Run/Stop Cables

I bought this cable for my Tilta Handle and my Sony Alpha 7 III but it doesn?‘t work ar all ...

It works great on my C500. It would be nice if the TRS plug side was straight and not an elbow but not a huge factor.

Works well just plug and play

Works flawlessly with the Ursa Mini Pro G2

Works great to activate run/stop - still need the p-tap power cable plugged into the motor.

Does the job. What else? Perfect if the end is right angled, but still served it?‘s purpose. Amazing support from tilta as always.

I've bought this cable to use with my DSMC1 Red Epic MX to use in control port (The cable is RED DSMC2).
I have connected the cable to the motor, also the motor is powered via D-Tap. No matter what setting i choose in camera -the cable doesn't work.
My camera settings are:
Redlink command protocol - tried enabled and disabled
BRAIN GPIO HIGH: Start Record
BRAIN GPIO LOW: Stop Record
GPIO - have tried Sync Out and Record out
What am I doing wrong? AC's told me this cable is the better one to use with DSMC1 cams. Is the cable faulty? I've tried to reboot the handles etc. - nothing works

On est it?‘s complicated when we need to recalibrate the motors especially when the are hoot lenses, and the calibrate of the knob. It should be easier and more rapid, we do not want any directors waiting for us to figure out how to calibrate the lens, but oh sorry we did not calibrate de knob, oh sorry we?‘re we at the Fraser?‘s it closest when we calibrated..,. Anyway stuff like that should be easy

R/S works fine, but still need to run a power cable for the motor. meh.

It?‘s works, but you must remove the side handle, it?‘s a huge pain because operators love the handle. This cable should have been made for the remote port.

Works like it should, perfect